SKU: 5791598726
Ships within 48 hours · Estimated delivery Aug 24 - Aug 29
the mounts raise the equipment off the floor for easier cleaning and inspection
12 bit resolution
This flow control fitting is used to control the speed of the cylinder's extend and retract motions
This M8 3-wire connector cable is used with most Wild Goose Filling systems and has one molded female end and three wires on the other
Tread: Flat Tread
Can Present Sensor with Quick Connect electrical the mounts raise the equipmentThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.
US$ 323.00
US$ 439.00
US$ 1141.00
US$ 462.00
US$ 2637.50
US$ 323.00
US$ 206.00
US$ 164.00
US$ 545.00
US$ 293.00
US$ 346.00
US$ 162.00
US$ 462.00
US$ 141.00
US$ 580.00
US$ 177.00
US$ 1645.60
US$ 931.00
US$ 177.00
US$ 265.00
